Xeni-Audio - Swarm - Purchase
by Tony CUNY
€39
Swarm: the mix that mixes itself
A mixing plugin that makes your tracks get out of each other's way — on their own.
Every mix hits the same wall. The guitar and the keys fight over the same frequencies. The vocal disappears the moment the chorus lands. One track jumps,
another drops, and you spend the afternoon drawing automation, notching EQs and patching sidechains just to keep everything audible.
Swarm handles that for you.
How it works
Drop one Swarm on each track you want to look after — guitar, vocals, bass, keys, drums. Give them all the same Link Slot number. That's it: they're now a swarm.
From that moment on, every instance listens to its own track - where it sits in the spectrum, how loud it is, where it sits in the stereo image - and talks to all the others, in real time. Each one then makes tiny adjustments to its own EQ, level and stereo position so the whole mix stays clear.
Nobody is in charge. There's no master instance, no analysis pass, no rendering step. It's the same principle as a flock of birds: simple rules, followed by everyone at once, producing behavior that looks intelligent. Your tracks negotiate with each other while the music plays.
Turn it off and you'll hear what it was doing.
What it actually does
Swarm applies four rules. Each one has its own control, so you decide how much of each you want.
Separation: when two tracks collide in the same frequency range, one steps back and the other steps forward. Like a dynamic EQ, except you never have to tell it where to cut. It finds the collision itself, and it moves as the music moves.
Alignment: tracks settle into a common level and breathe together. When one lifts, the others follow, gently. It's not compression: it's a band of musicians listening to each other.
Cohesion: pulls each track's tone towards a shared center of gravity, so the mix sounds like it belongs together. Nothing gets flattened: a dead zone protects the extremes, so your bass stays a bass.
Pan Spread: tracks piling up in the same spot of the stereo image drift apart. Guitar left, keys right, without touching a pan pot. Fully mono-compatible - no phase tricks, no delay. Anything that must stay dead center (kick, bass, snare) gets a Pin Center switch.
One Intensity knob rides all four at once. Start at 100%. Pull it down for something almost subliminal, push it to 300% if you want to hear the swarm clearly.
You can watch it happen
The center of Swarm's window is a live map of your mix. Every track is a glowing dot — left to right is dark to bright, bottom to top is quiet to loud. Your track is the orange one, and each peer carries its own color and shape, so the map reads even if you don't see color well.
Each dot also carries a vector: the dot is where the track sits, the arrow is where the swarm is pushing it. That is the part most analysers never show you: not the signal going in, but the correction coming out. Watch a guitar and a synth fighting over the same register and you see the two arrows pointing apart, in real time, before you hear what it did.
Also in the box
Crest: a transient designer per track. Push it up for punch, down for density. It greys itself out on already-crushed material instead of pretending to work.
Link Params: steer the entire swarm from a single window. Change Intensity on one instance, every other instance follows.
Multiple swarms: slot 0 for the rhythm section, slot 1 for the vocals. As many independent groups as you want, in the same session.
5 presets: Init, Subtle, Wild, Spectral Only, Spatial Only — plus your own, with A/B compare and 20 levels of undo.
Metering: in, out, gain reduction, crest and LUFS (BS.1770), right there at the bottom.
A help bar: hover any control and it tells you, in plain English, what it does.
Who it's for
You mix your own music and you'd rather spend the time on the music.
Your sessions run 15, 30, 60 tracks and the low-mids are a warzone.
You want the glue of a good mix without printing a single automation lane.
You're curious about what your mix actually looks like from the inside.
It's not a mastering plugin and it's not a magic button. It's a mixing assistant that works while you work.
Try before you buy
Swarm has a free demo, and it is the full plugin - every feature, every preset, your settings saved. The only limit is that the audio mutes for 5 seconds every minute, with fades so it never clicks.
Grab it from https://xeni-audio.com (or from the free Swarm demo page here on Gumroad), install it, and run it on a real session for as long as you like.
When you're convinced, buy your license on this page. You'll receive a key - click the DEMO badge in the plugin, paste it in, hit Activate, and the muting is gone for good.
Your license is permanent, works on all of your machines, and includes free updates. No subscription, no online check every time you open a session, no account to keep alive.
Specs
Formats: VST3, CLAP (Windows, macOS, Linux) and AU (macOS)
macOS: universal - Intel and Apple Silicon (M1/M2/M3/M4)
Windows: installer or portable ZIP
Linux: VST3 + CLAP
Stereo in / stereo out
Full user manual (PDF) included
*macOS: signed with an Apple Developer ID and notarized by Apple: it just opens. The publisher reads "Tony Cuny", the legal name behind Xeni Audio.
Windows: the installer is not signed yet, so SmartScreen may say the publisher is unknown — "More info" → "Run anyway", or use the portable ZIP instead.*
Swarm 1.3.1
FIXED
macOS: ⌘V, ⌘C, ⌘X, ⌘A and ⌘Z now work in the license key field, whatever the host's Edit menu does with them.
Linux: closing the plugin window no longer risks a crash while the idle timer is still running.
Swarm 1.3.0
NEW
Track Role presets. Eight factory presets — Kick, Bass, Drum Bus, Lead Vocal, Backing Vocals, Guitars, Keys & Synths, Pads & Ambience — set an instance up for the kind of track it sits on: how much it yields (Intensity), which end of a clash it claims (Bias) and whether it stays out of the pan flock (Pin Center). One click per track gets the priorities right; Intensity stays yours to taste. The sound presets (Init, Subtle, Wild, Spectral Only, Spatial Only) are unchanged and still leave Bias and Pin Center alone.
Your own presets now store Bias and Pin Center as well. Presets saved by an earlier version load exactly as before and leave both untouched.
FIXED
Undo/redo and A/B compare captured Pin Center and Link Slot instead of the two Crest controls. Switching between A and B could therefore move an instance to another Link Slot, and never recalled Crest. Both now follow the eight sound controls, as intended.
Two mono-recorded doubles panned to the same side by their host could both be pushed to the same side by Pan Spread, because the tie-break compared positions each instance numbered locally. It now uses the flock-wide slot, so the pair splits left/right as intended.
The French manual shipped with 1.2.2 still named the 1.2.1 downloads.
Swarm 1.2.2
FIXED
Swarm no longer requires AVX2. The Windows and Linux builds now run on any x86-64 processor, including AMD FX/Phenom and Intel chips from before 2013. On those machines the symptom was a host that scanned the plugin forever — nothing ever mentioned AVX, which is what made it hard to recognise.
Windows: the editor window could fail to open over Remote Desktop, in a virtual machine, or on a machine with no GPU driver, and could freeze on an otherwise valid graphics context. Four separate defects in the window setup, all fixed.
The size you set by dragging the host's own window frame is now kept — both while you drag, which preserves the aspect ratio, and when you close and reopen the editor. On Windows this had never worked.
The editor reopens at the size you chose rather than the size the host last granted it.
Swarm 1.2.1
A single fix, for a single host.
FIXED
Cubase and Nuendo (Windows) no longer crash while Swarm's resize grip is being dragged.
CHANGED
As a consequence, in Cubase and Nuendo the resize grip in the bottom-right corner no longer does anything, and the window size is not remembered between editor openings. Resize Swarm with the host's own plugin-window frame.
Swarm 1.2.0
The release where Swarm finally shows you what it is doing.
NEW
Bias, per instance: when two tracks fight over the same register, you now choose which one takes the top of it. Centred, it behaves exactly
as before.
On VST3, each instance takes its name from the host track.
macOS installers are signed with an Apple Developer ID and notarized: no more right-click-to-open. (The Windows installer is still unsigned.)
FIXED
The feature space showed each track's INPUT and never the corrections Swarm applied. Every dot now carries a vector: where the track is, and
where the swarm is pushing it. The manual said otherwise; that was wrong and is corrected.
The dots twitched because the horizontal axis was unsmoothed while the vertical one carried a 5-second average. They now move at the speed
Reactivity actually says.
The Boids view stays on its own page instead of drawing underneath every other display.
Color-blind readability: the EQ and GAIN bars no longer differ by hue alone, and every peer carries a shape as well as a color.
The instance name under the title was very nearly invisible, and the double-click-to-rename it hid was undiscoverable. Both fixed.
macOS: window resizing now works in every host tested, the first-open offset and the un-draggable window are gone, and reopening no longer restores half your saved zoom on a Retina display.
Swarm 1.1.2
One fix, and it matters if you run Swarm on more than a handful of tracks.
FIXED
Instances loaded a few seconds apart could take a slot another instance was already using. On a large session that left some instances invisible to the rest of the flock, and made the peer count jump around. Ten instances now reliably see all ten.
If your flock ever felt like it was barely reacting on a big session, this is the update.
Swarm 1.1.1
One fix, and an important one if you run Swarm on many tracks.
FIXED
Instances that were already loaded when you activated your license kept muting as if still in demo. Activation is now picked up by every instance within a couple of seconds, whether or not its window is open.
If you ever heard the demo mute on a licensed session, this is the update.
Swarm 1.1.0
More room for big sessions, asked for on the launch thread.
NEW
16 swarm groups instead of 5 (Link Slot 0–15).
Up to 64 instances in a session instead of 16.
The Link Slot menu is now a grid, so picking a slot stays one click.
Enough to give a full orchestral template one group per section rather than forcing everything into one swarm.
Swarm 1.0.2
A single fix, reported on the launch thread.
FIXED
Windows: the plugin window could come up blank, or not come up at all, in Cubase. Swarm now shows its editor even when the host leaves the window it embeds us in marked as hidden.
If you were affected, this is the one to install. Free update for all owners - same license key.
Swarm 1.0.1
NEW
Every instance now shows what the swarm is applying to it — EQ tilt, gain, pan and transient — as live meters.
A flock legend lists every track in the swarm. Hover one to inspect it and to see which dot is which in the feature space.
Demo mutes are now synchronized across all instances, so a multi-instance demo can actually be judged.
FIXED
Activation could be lost if the license window was closed while the key was still being checked online.
The swarm applied a spectral tilt over silence, which then unwound during the first second of playback.
The gain-reduction meter read full when nothing was being attenuated.
Track names next to the agents in the feature space were often missing.
MANUAL
New section on setting priority between tracks (how to make the kick win over the bass), and a rewritten Link Params section.
Xeni-Audio - https://xeni-audio.com